Lowriders

UCYI3WL · 08-21-2002, 07:44 PM

This is the question i posted on their site to start the interior this evening:

I have a 94 4 door integra. On the door panels, there is a patch for better lack of words of fabric the same as the seats. How do you remove these so you can reupholster those spots where interior fabric already exists??

The answer:
A big knife, like crocidile dundee

Im like go to hell you bastard
Any ideas on this question guys/gals??

DRLOWZ · 08-21-2002, 08:46 PM

I would say there is either some type of metal clips on the backside of the panel or it is glued on by the factory. If that doesnt work get A big knife, like crocidile dundee and pry it off...

08-23-2002, 08:34 PM

when u get the knife remember to take a good hard look at it.. and if u can honestly get by wihtout saying

that aint a knife this is a knife.. then that should work

u should ask orange about the size of the knife you need after all he is aussie

08-21-2002, 07:44 PM	#1 (permalink)
UCYI3WL UnitedRidaz C.C. Join Date: Jun 2002 Location: Birmingham, AL Posts: 2,813	No Help from Integra site This is the question i posted on their site to start the interior this evening: I have a 94 4 door integra. On the door panels, there is a patch for better lack of words of fabric the same as the seats. How do you remove these so you can reupholster those spots where interior fabric already exists?? The answer: A big knife, like crocidile dundee Im like go to hell you bastard Any ideas on this question guys/gals??

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads for: No Help from Integra site
Thread	Thread Starter	Forum	Replies	Last Post
Help with a Web Site???	alaskan_og	Lowrider Discussions	3	05-19-2003 08:47 AM
NEW TO THE SITE	MAUIMALIBU78	Off Topic	10	03-31-2003 04:05 AM

08-21-2002, 08:46 PM	#2 (permalink)
DRLOWZ Administrator Join Date: Jun 2002 Location: Bardstown,Kentucky Posts: 4,936	I would say there is either some type of metal clips on the backside of the panel or it is glued on by the factory. If that doesnt work get A big knife, like crocidile dundee and pry it off...

08-23-2002, 08:34 PM	#3 (permalink)
UnitedRidaZ Posts: n/a	when u get the knife remember to take a good hard look at it.. and if u can honestly get by wihtout saying that aint a knife this is a knife.. then that should work u should ask orange about the size of the knife you need after all he is aussie

Lowriders

No Help from Integra site

No Help from Integra site