[raul zamarripa]

Originally Posted by Unique 93

Any body putting together a hopper, got a few ideas..

yeah im thinking about buying a hydraulic kit i got about 2,000 dollars and i wanted to know what you guys think about cce hydraulics ive been looking at the fat boy kit and the fuerte kit

[DRLOWZ]

If its customer service you are looking for, I ve had nothing but bad experiences with them....purchased some wires from them a while back and the chrome chipped off one wheel within a few months...not curbed just flaked...and they would not replace it.....boooo..

[pumps77]

Originally Posted by Still Hated

I heard about using Caprice arms and spindles but havent seen anybody down here using them on the street. The car i have is different, 4-door cutlass, single pump-10 batteries.

JUST ARMS NOT SPINDELS NEEDED. BEEN HOPPIN WITH MY CUTLASS FOR TWO YEARS NEVER HAD PROBLEMS WITH MY CAPRICE ARMS

[Miser211]

Originally Posted by spence

came up with a block that can be used with four pumps at the same time
, all four pumps are plumbed into the block so you can use one pump or use
all four at once . And direct the flow to any cylinder. unlike a standard four
pump set where you have one pump per cylinder, this block can put the flow
of all four ,three ,two or one pump to one cylinder , or use all four pumps to
the front (two pumps for left front / two pumps for the right front ) and the
same for the side ,all four pumps to one side. Even if three pumps are dis-
abled one pump can still raise all four cylinders ,just a little slower of couse
I have one block im doing testing on and should be ready in a week or so.
Im on vacation right now so I wont be able get back to till jan. 3 2006 just
came in to work today only to finish a 85" long rodless cylinder? so if you are
still interested just reply ,Ill get back to you on the 3 rd.

[JUSWESTCOASTIN]

last post september 2006

[wicked77]

so if i have a g-body i can use caprice a-arms to get a extened look?

[Miser211]

Originally Posted by wicked77

so if i have a g-body i can use caprice a-arms to get a extened look?

with some modification you will get more than the extended look they will be extended almost 1"