|
| Home Forums Gallery Rides Application Featured Ride |
| Sponsor The Hydraulics & Suspensions Forum at United
Ridaz. Click Here For More Details |
| Discuss Whos gonna come to MI and work on ma ride? in the Hydraulics & Suspensions Forum. Need an o ring in ma rear cylinder, and ma rear trailing arms put on. ........... |
| ||||||
 |
| | LinkBack | Thread Tools | Display Modes |
08-06-2002, 07:55 PM
| #2 (permalink) |
| Administrator  Join Date: Jun 2002 Location: Bardstown,Kentucky
Posts: 4,938
   |  well I'm not coming to Mi. Been there, roads are to bad. especially in Detoit. But we will walk you through your problems. Or ing in cylinder is easy. Take out cylinder from car. Undo big donut nut on cylinder, may need some channel locks. After you have that unscrewed push shaft out from other end( you may need to put screwdriver in fitting end and push, being carefull not to hot cylinder wall. there you go the orings are right there on the end of the shaft. They will tell you at the hydro shop that them are special orings for hydros but you can go to home depot and match it up and will cost you about 55 cents. |
|  |
|
08-08-2002, 02:01 PM
| #3 (permalink) |
| UnitedRidaz C.C.  Join Date: Jun 2002 Location: Giant sink hole in FLA.
Posts: 2,943
| 55 cents..... Dammit boy, I remember when o-rings that size were 30 cents....... Remember to put the lil white scrappers back in the same position, I would buy those from a hydro shop, unless you find them at the Depot also. |
|
| |
Linear Mode
