cylenders(sp)

SkarDawg · 06-28-2002, 08:26 PM

OK can I have cylenders installed on my car but not hooked up to pumps or will this mess them up....

hittin back bumper · 06-29-2002, 12:41 AM

nope, i rode around wit one cylinder on my truck for about a week and dident mess it up, i dont it will mess up.

rlowride · 06-29-2002, 01:11 AM

naaa, it will be ok for awhile, just make sure to cover/seal the port so as to keep dirt out of it.

SkarDawg · 06-29-2002, 07:29 AM

sweet I think when I get the frame down up ((by the way what is normaly done 1/4 inch or 1/2 inch)I will just have them install the cylenders and shit.....

UCYI3WL · 06-29-2002, 01:27 PM

I use 1/4 inch...

SkarDawg · 06-29-2002, 08:31 PM

cool thanks someone told me too use 1/2 so I wasn't sure..........

06-28-2002, 08:26 PM	#1 (permalink)
SkarDawg Registered User Join Date: Jun 2002 Location: The Dalles, OR Posts: 334	cylenders(sp) OK can I have cylenders installed on my car but not hooked up to pumps or will this mess them up....

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-29-2002, 12:41 AM	#2 (permalink)
hittin back bumper Registered User Join Date: Jun 2002 Location: Palestine, Texas Posts: 10	nope, i rode around wit one cylinder on my truck for about a week and dident mess it up, i dont it will mess up.

06-29-2002, 01:11 AM	#3 (permalink)
rlowride UnitedRidaz C.C. Join Date: Jun 2002 Location: Giant sink hole in FLA. Posts: 2,967	naaa, it will be ok for awhile, just make sure to cover/seal the port so as to keep dirt out of it.

06-29-2002, 07:29 AM	#4 (permalink)
SkarDawg Registered User Join Date: Jun 2002 Location: The Dalles, OR Posts: 334	sweet I think when I get the frame down up ((by the way what is normaly done 1/4 inch or 1/2 inch)I will just have them install the cylenders and shit.....

06-29-2002, 01:27 PM	#5 (permalink)
UCYI3WL UnitedRidaz C.C. Join Date: Jun 2002 Location: Birmingham, AL Posts: 2,813	I use 1/4 inch...

06-29-2002, 08:31 PM	#6 (permalink)
SkarDawg Registered User Join Date: Jun 2002 Location: The Dalles, OR Posts: 334	cool thanks someone told me too use 1/2 so I wasn't sure..........