UnitedRidaz Lowrider Forums - View Single Post

Unity_Jon · 11-12-2002, 07:06 AM

you can do as much as you like, I did my door panels like this...

cut a large sheet of foam and stuck it to the bare panel, drew the diamond shapes over it then used and electric carving knife to cut along the lines, layed my material over the top and started tucking it into the cuts from the middle and worked out to the edge, when i had it all sorted i ran staples down in the cuts to hold the material in place as i wasn't having buttons.

hope this helps.

11-12-2002, 07:06 AM	#2 (permalink)
Unity_Jon Registered User Join Date: Jun 2002 Location: United Kingdom Posts: 240	you can do as much as you like, I did my door panels like this... cut a large sheet of foam and stuck it to the bare panel, drew the diamond shapes over it then used and electric carving knife to cut along the lines, layed my material over the top and started tucking it into the cuts from the middle and worked out to the edge, when i had it all sorted i ran staples down in the cuts to hold the material in place as i wasn't having buttons. hope this helps.