Quote:
|
Originally Posted by juicedoutsoon
k this is confusion lol i'll just wire my own switches now this is for good no more changin mind lol....... Okay so i need 4 3 prong carling switches rite, i want each switch to control a wheel but one problem is each switches would need a power so that 4 power wires and 4 ring connector and they all need 24v, how all those ring connectors would fit on the second batts is there a better way in doin this????? Or can i have one switch going to the second batt and i just splice the other 3 into that one wire or what????? Also what connectors do i use on the carling switch like the prongs?
ALso is unitedridaz are u dennis, if not you been helping me alot hehhehehehe..........
THANKS............
|
naw man im chuck hope this diagram helps.. u should solder them but u can use the little o ring connectors ignore the op 4 switches on the diagram u only need the bottom 4 run 1 24 volt wire to ur first switch and jump from switch to switch after that make sure both siders of the switch have power by connecting ur 24 volt wire to both sides of the switch